Repose® products can be used in patients up to 300 lbs (139 kg) . There is no minimum weight limit. Patients at the upper end of the weight range should be monitored regularly.

Exceptions:

• Mattress topper system and double mattress topper system when used with a high-quality foam mattress: up to 222 kg.
• Mattress topper system and double mattress topper system when used with a regular foam mattress: up to 139 kg.
• Other products (e.g. wedge, leg protector, pillow, Contur, wheelchair mattress, Companion, Care-Sit, Companion stretcher): up to 139 kg.
• Babynest: max. 3 kg, no lower limit.

Clean with soap and water . If necessary, you can use a chlorine-based disinfectant (not phenol-based). Allow the product to dry completely before repacking it in the tube.

Detailed cleaning instructions are included in the package.

Punctures are rare and are usually caused by pets. We have no evidence of the safety of using Repose® after repair, so we recommend replacing the product if damaged .

Repose® has been tested to BS: 7175 Crib Test 5 (a test for the flammability of blankets and pillows to smouldering and flaming ignition sources) and also meets 16 CFR Part 1632 (a standard for the flammability of mattresses and mattress pads).

Inflation procedure:

1. Remove the product from the tube and use it as a pump.
2. Connect to the valve and start inflating.
3. Stop as soon as you hear the air flowing back.
4. A click indicates correct inflation.
5. Disconnect and close the valve with the solid end of the cap.
6. Check the pressure regularly, top up with air no later than every two weeks .

No, but most patients find it more comfortable and caregivers appreciate the easier maintenance. If you use a sheet, it should be loosely laid to avoid unwanted tension (the "hammock effect").

Repose® is a low-profile mattress with no metal or electrical components , so it can be safely used during CPR.

Repose® is a certified medical device (CE). At the end of its useful life, it should be disposed of as medical waste according to local regulations, or it can be incinerated with medical waste .

No, Repose® has not been tested for use with electric blankets, so combining them is not recommended .

Yes, as with all pressure mattresses, normal procedures for regular patient positioning should be followed .

No, Repose® is latex-free and hypoallergenic .

Repose® material is not certified as non-slip , but it does have some grip that helps reduce slipping.

Yes, the Repose® mattress loading system can be used on both adjustable and tilting beds .

Yes, socks are not a problem because the heel is completely lightweight.

No, Repose® Care-Sit is designed for static chairs and regular wheelchairs . There is a risk of the patient slipping when used on a positioner chair .

Repose® is intended for the prevention and treatment of all stages of pressure ulcers in patients at risk.

Yes, but a patient slip risk assessment must be performed.

There is no evidence that Repose® increases the risk of skin damage from moisture. The surface of the material helps to wick away moisture and a pillowcase can be placed over it if needed (again, with an assessment of the risk of slipping).

Yes, Repose® can be used in an air ambulance . When used at higher altitudes, it is recommended to inflate the product only after reaching the target altitude .

No, Repose® is not intended for use in a car as it has not been tested to the relevant vehicle safety standards.

Yes, Repose® has been tested according to ISO 10993-1:2018 (biological evaluation of medical devices) and does not cause any negative skin reactions .

Yes, there is evidence that Repose® helps treat pain in patients with rheumatoid arthritis .

No, because the adjustable strap contains magnets , it is not suitable for patients with pacemakers .